For the mobile engineer, a blower is a device which is vital in search of food. Let us discuss the problem of the use and maintenance on the blower. So that the blower is always well maintained, it takes a special technique in use. In other words, their use should not be random. This is done so that the blower can last a long time despite frequent use.
Perhaps the following steps can be tried:
1 Prepare blower.
2 Turn on the blower with air setting (water) in one to two.
3 Settings heater (heat) at 300 to 400 degrees
4 After setting is set, pick up the blower. Grasp the handle of the blower in a vertical or perpendicular. This is done to optimize the heat power that will be issued by the blower.
5. To be considered also is the distance between the blower with the components that will be installed or dismantled. Is approximately between half to one cm.
6 The process of heating the component starts. Navigate to the component of wind heat evenly. Do it many times and do not be too long hinga tin or IC component would be appointed already melted.
7 If it is raised, remain on the solder back into place. Allow a few moments until the water heater and demonstrate to the number 0
8. cooling process itself should be done. Let the rest of the hot air issue is still there. Approximately half minutes.
9 Do not ever try to simply unplug the power, after the completion blower is used, because it can lead to the blower will be quickly damaged.
10 Turn off the blower by pressing the power OFF.
Similarly, the use of practical ways blower with good care as well.
Good luck and good luck !!
0 Response to "Easy to Use Tips For Raising Blower BGA IC"
Post a Comment